MARGINAL AND INTERNAL FIT OF SINGLE TOOTH-SUPPORTED CROWNS: WHAT DOES THE COMPARISON BETWEEN DIGITAL AND CONVENTIONAL WORKFLOWS ACTUALLY MEASURE? A NARRATIVE REVIEW
DOI:
https://doi.org/10.51891/rease.v12i11.32170Keywords:
Dental crowns, Computer-aided design, Marginal adaptation dental, Dental impression technique, ReviewAbstract
Comparisons between digital (CAD/CAM) and conventional workflows for single crowns are often framed as a single contrast, yet they involve at least two distinct steps: acquisition (digital scanning or conventional impression) and fabrication (CAD/CAM milling or conventional methods such as casting). This narrative review critically examines six in vitro studies published between 2022 and 2026, identified through a structured search of PubMed/MEDLINE, SciELO, and LILACS, addressing marginal and internal fit. For acquisition, one study found smaller gaps with digital scanning, whereas another found the smallest marginal mean with polyether impressions. For fabrication, milling showed marginal fit similar to conventional methods in three studies and smaller in one, with smaller internal gaps in two studies and region-dependent results in a third. The analysis suggests that apparently conflicting results largely reflect differences in comparator, material, preparation, measured region, and measurement method, and that some so-called conventional comparators contained digital steps. Because all studies were laboratory-based and none reported assessor blinding, the findings cannot be extrapolated to clinical performance. Criteria for interpretable workflow comparisons and priorities for clinical studies are proposed.
Downloads
Downloads
Published
Issue
Section
Categories
License
Atribuição CC BY